![]() ![]() To set the snapping tolerance with pointer, complete the following steps. You can set the snapping tolerance on-screen with the pointer, or type a tolerance distance. ![]() Snapping to specific layers by using the List By Snapping tab in If you need to further refine snapping, consider isolating On the scale of your data and the complexity of the features in your The optimal snapping tolerance distance depends The snapping tolerance is the 2D XY planarĭistance between the pointer and a geometric element within whichĪn enabled snap agent snaps the pointer. Set the snapping tolerance with the pointer Move the pointer back to the map and proceed to create or modify features.Snap to the nearest point of tangency on an arc or curved segment. Snap to the nearest midpoint of a polyline or polygon segment. Snap to the nearest intersection of two or more lines or edges. Snap to the nearest edge of a polyline or polygon segment. Snap to the nearest vertex of a polyline or polygon feature. Snap to the nearest start point or endpoint of a polyline feature. Snap to the nearest point or LAS point feature. Turn snapping on and off to control when the enabled snap agents are applied to the pointer. To configure advanced settings, click the Snapping Settings on the Snapping dialog box.Įnable a combination of snap agents that help you work efficiently and accurately.To turn snapping on or off by layer, click the List By Snapping tab in the Contents pane.You can press the Spacebar to temporarily turn off snapping as you create, modify, or measure features.When you use snapping, consider the following: Door and window grids positioned between the panes make the window easiest to clean, though interior and exterior grids usually are designed as snap-in grids. Concurrently, snap tips appear near the pointer showing the type of snapping that is actively snapping the pointer. When snapping is on and you hover near a feature, the enabled snap agents snap the pointer to the geometry element if it is within the snapping tolerance. Snapping is available on the status bar, and on the ribbon, on the Edit tab. Snap agents specify the geometric element to which the pointer snaps. Snapping is a configurable drawing aid that controls the accuracy of the pointer when you hover near a vertex, an endpoint, or other geometric element. Set the snapping tolerance with the pointer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |